Enterasys Networks RBT-4102 manual Using the CLI to Configure Radius MAC Authentication

Security

Using the CLI to Configure RADIUS MAC Authentication

Use the mac‐authentication server command from the Interface Wireless or Interface Wireless: VAP configuration modes to enable remote MAC authentication. Set the timeout value for re‐ authentication using the mac‐authentication session‐timeout command. Specify a password for the AP to send to the RADIUS server for MAC authentication using the mac‐authentication password command. Be sure to also configure connection settings for the RADIUS server (not shown in the following example).

Examples

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z RoamAbout 4102(config)#interface wireless a

Enter Wireless configuration commands, one per line. RoamAbout 4102(if-wireless a)#mac-authentication server remote RoamAbout 4102(if-wireless a)#mac-authentication session-timeout 300 RoamAbout 4102(if-wireless a)#mac-authentication password *****

RoamAbout 4102(if-wireless a)#vap 6

RoamAbout 4102(if-wireless a: VAP[6])#mac-authentication server remote

RoamAbout 4102(if-wireless a: VAP[6])#mac-authentication session-timeout 300

RoamAbout 4102(if-wireless a: VAP[6])#mac-authentication password *****

RoamAbout 4102(if-wireless a: VAP[6])#exit RoamAbout 4102#

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-91