TCP / IP Settings
TCP / IP Settings
Configuring the RBT‐4102 with an IP address expands your ability to manage the access point. A number of access point features depend on IP addressing to operate.
Note: You can use the web browser interface to access the access point if the access point already has an IP address that is reachable through your network.
By default, the RBT‐4102 will be automatically configured with IP settings from a Dynamic Host Configuration Protocol (DHCP) server. However, if you are not using a DHCP server to configure IP addressing, use the CLI to manually configure the initial IP values (Refer to Chapter 3, Initial Configuration). After you have network access to the access point, you can use the Web browser interface to modify the IP configuration, if needed.
Note: If there is no DHCP server on your network, then the access point will automatically start up with its default IP address, 192.168.1.1.
RoamAbout