Enterasys Networks RBT-4102 manual Radio Settings

Radio Interface

Radio Settings

Using Web Management to Configure Interface Radio Settings

Select Radio Settings under the type of interface (802.11a or 802.11b/g) that you want to configure.

Note: The WMM and Virtual AP fields (not shown here) are discussed later in this section.

•Interface Status disables/enables use of this default radio interface. Default: Enable.

Notes: Before enabling the radio card, you must set the country selection, if applicable, using the CLI. For more information, see the Enterasys RoamAbout Wireless RBT-4102 Installation Guide.

You must enable the default radio interface in order to configure VAPs on this radio interface.

•Description is the description you provide to identify this default radio interface.

•Network Name (SSID) The name of the basic service set provided by a VAP interface. Clients that want to connect to the network through the access point must set their SSID to the same as that of an access point VAP interface. Default: VAP_TEST_11A (0 to 3). Range: 1‐32 characters.

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-57