Security
Using the CLI to Configure WEP over 802.1x Security
From the interface wireless or interface wireless: VAP configuration modes, use the authentication command to select open system authentication. Use the cipher‐suite command to select WEP cipher type. Set 802.1x to required with 802.1x command. Disable MAC authentication with the no mac‐authentication command.
Examples
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface wireless g
Enter Wireless configuration commands, one per line.
RoamAbout
RoamAbout
RoamAbout
Unicast Ciphers can accept TKIP only.
Multicast Cipher is set to WEP.
RoamAbout
RoamAbout
RoamAbout
To view the current 802.11g security settings, use the show interface wireless g command.
RoamAbout 4102#show interface wireless g
Wireless Interface Information
=========================================================================
Description | |||
SSID | : ETS | ||
802.11g band | : | 802.11b + 802.11g | |
Channel | : | 6 |
|
Status | : Enable | ||
: External | |||
Antenna Select | |||
Antenna ID | : 0x0183(Ext. | ||
: | 0 | us | |
| |||
Transmit Power | : FULL (6 dBm) | ||
Automated Data Rate | : ENABLED | ||
Max Station Data Rate | : 54Mbps | ||
Multicast Data Rate | : 1Mbps | ||
Fragmentation Threshold | : | 2346 bytes | |
RTS Threshold | : | 2347 bytes | |
Beacon Interval | : | 100 TUs | |
Association Timeout Interval | : | 5 | Mins |
DTIM Interval | : | 2 | beacons |
Preamble Length | : | LONG | |
Maximum Association | : | 255 stations | |
Native VLAN ID | : | 1 |
|
Software Retry Mode | : | DISABLED | |
Software Retry No | : | 3 |
|
Hardware Retry No | : | 4 |
|
: DISABLED | |||
Secure Access | |||
Multicast cipher | : WEP | ||
Unicast cipher | : | ||
PMKSA Lifetime | : | 720 minutes | |
WPA clients | : | NOT SUPPORTED |
RoamAbout