Enterasys Networks RBT-4102 manual Using the CLI to Configure WEP Shared Key Security

Security

Using the CLI to Configure WEP Shared Key Security

From the interface wireless or interface wireless: VAP configuration modes, use the authentication command to enable WEP shared‐key authentication and the encryption command to enable WEP encryption. Use the cipher ‐suite command to select WEP cipher type for broadcasting and multicasting. To enter WEP keys, use the key command (from the interface wireless mode only), and then set one key as the transmit key using the transmit‐key command. If necessary, disable 802.1x port authentication with the no 802.1x command.

Note: The index and length values used in the key command must be the same values used in the encryption and transmit-keycommands.

Examples

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 4102(config)#interface wireless g

Enter Wireless configuration commands, one per line.

RoamAbout 4102(if-wireless g)#authentication shared

RoamAbout 4102(if-wireless g)#encryption

RoamAbout 4102(if-wireless g)#cipher-suite wep

Unicast Ciphers can accept TKIP only.

Multicast Cipher is set to WEP.

RoamAbout 4102(if-wireless g)#key 1 128 ascii 1234567890123

RoamAbout 4102(if-wireless g)#transmit-key 1

RoamAbout 4102(if-wireless g)#vap 2

RoamAbout 4102(if-wireless g: VAP[2])#authentication shared

RoamAbout 4102(if-wireless g: VAP[2])#enc

RoamAbout 4102(if-wireless g: VAP[2])#cipher wep

Unicast Ciphers can accept TKIP only.

Multicast Cipher is set to WEP.

RoamAbout 4102(if-wireless g: VAP[2])#transmit 1

RoamAbout 4102(if-wireless g: VAP[2])#exit

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-93