Snmp Notifications Description | Enterasys Networks RBT-4102

SNMP

•SNMP allows you to enable or disable SNMP management access and also enables the access point to send SNMP traps (notifications). SNMP management is enabled by default.

•SNMPv1 allows you to enable or disable management access from SNMPv1 clients.

•Community Name (Read Only) defines the SNMP community access string that has read‐only access. Authorized management stations are only able to retrieve MIB objects. Default: public, maximum length: 23 characters, case sensitive

•Community Name (Read/Write) defines the SNMP community access string that has read/write access. Authorized management stations are able to both retrieve and modify MIB objects. Default: private, maximum length: 23 characters, case sensitive

•Trap Destination (1 to 4) enables or disables each of the four available trap destinations. If enabled, you must define the trap destination using the IP address and community name fields.

•Trap Destination IP Address (1 to 4) specifies the recipient of SNMP notifications. Enter the IP address or the host name. Host Name: 1 to 20 characters

•Trap Destination Community Name specifies the community string sent with the notification operation. Default: public, maximum length: 23 characters, case sensitive

•Trap Configuration allows selection of specific SNMP notifications to send. Table 4‐3 lists the available notifications.

Table 4-3 SNMP Notifications

Notification	Description

sysSystemUp	The access point is up and running.

sysSystemDown	The access point is about to shutdown and reboot.

sysRadiusServerChanged	The access point was changed from the primary RADIUS
	server to the secondary, or from the secondary to the primary.

dot11StationAssociation	A client station successfully associated with the access point.

dot11StationReAssociation	A client station successfully re-associated with the access
	point.

dot11StationAuthentication	A client station was successfully authenticated.

dot11StationRequestFail	A client station failed association, re-association, or
	authentication.

dot1xAuthFail	A 802.1x client station failed RADIUS authentication.

dot1xMacAddrAuthSuccess	A client station successfully authenticated its MAC address
	with the RADIUS server.

dot11InterfaceAFail	The 802.11a interface failed.

sntpServerFail	The access point failed to set the time from the configured
	SNTP server.

dot1xMacAddrAuthFail	A client station failed MAC address authentication with the
	RADIUS server.

dot1xAuthNotInitiated	A client station did not initiate 802.1x authentication.

dot1xAuthSuccess	A 802.1x client station successfully authenticated by the
	RADIUS server.

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-31