Chapter 2 | C o n f i g u r i n g t h e I P A d d r e s s |
|
|
| The next step in the device configuration process is to configure an IP |
| address and access the device for more advanced configurations. You |
| must set the initial IP before you can use the web interface. Once the IP is |
| set, the device can be accessed through the web interface and any |
| changes made including changing the IP address. |
Options for Configuring the IP Address and Mask
The device server IP address can be configured using the following methods:
•With the Wizard from the Software and Documentation CD. (Insert the CD and the wizard automatically pops up for Microsoft Windows systems. If you have a UNIX system see the back of the quick start guide for mounting instructions.)
•With Digi Port
•From the command line, using the set config command. See the Digi Command Reference for more details.
•By updating the ARP table on a server and then pinging the Digi device (called
•Using a DHCP server ("Configuring an IP Address using DHCP and RARP" on page 15.)
•Using a RARP server ("Configuring an IP Address using DHCP and RARP" on page 15.)
The IP address and mask can also be changed using the web interface, but not for initial IP address configuration.
Device Support: Digi Port
Configuration
Not all Digi devices can use Digi Port
Device | Part Number | Revision Required |
Digi One IA RealPort | F or higher | |
|
|
|
Digi One RealPort | J or higher | |
|
|
|
PortServer TS 2 | J or higher | |
|
|
|
PortServer TS 4 | G or higher | |
|
|
|
Chapter 2 Configuring the IP Address | 13 |