Digi 90000583_A manual

Page 64

connected to a serial port, it must be configured, however.) If you configure a port for a master and the slaves are located on the network, TCP sockets, UDP sockets, and Modbus/TCP are all supported. Use the protocol required by the master.

64	Chapter 9 Special Features: IA (Industrial Automation)

Image 64

Contents Digi TS Family 90000583A Chapter Configuration Configuring the IP AddressChapter Introduction Setting Up RealPort Special Features WirelessSpecial Features Embedded Modem Special Features Modem EmulationSpecial Features Power Over the Serial Ports Special Features IA Industrial AutomationSpecial Features Snmp Configuration ManagementDigi Contact Information About This Guide Other Documents in the LibrarySetup Overview About Configuration Methods Supported DevicesFeature Products Availability Configuration Details Accessing the Configuration from the Web InterfaceQuick Find Table DNS Introduction Options for Configuring the IP Address and Mask N f i g u r i n g t h e I P a d d r e s sConfiguring the IP Address with Digi Port Authority-Remote Configuring the IP Address Using ARP-PingConfiguring an IP Address using Dhcp and Rarp Accessing the Digi DeviceButton in the upper right corner is also available Network Settings N f i g u r a t i o nProcedure for Using a Name Server Service Base Socket Network Port Configuring the Serial PortsConfiguration Port Profiles TCP Sockets Serial Bridging Printer Industrial Automation Modem Emulation Power Management Custom User Configuration Feature DescriptionSecurity Configuration Snmp SSHSystem Configuration Click Outgoing Connections Configuring a Port for Autoconnection About AutoconnectionConfiguring a User for Autoconnection T t i n g U p R e a l P o r t About RealPortSetting Up RealPort Configuration Considerations Select Discover Digi Device from the CDClick Network Wireless LAN Special Features Wireless Special Features Wireless E c i a l F e a t u r e s E m b e d d e d M o d e m Embedded ModemSpecial Features Embedded Modem E c i a l F e a t u r e s M o d e m E m u l a t i o n Modem EmulationModem Emulation Cable Signals Serial Device Digi DeviceOriginating, Answering, and Disconnecting Calls Scenarios for Modem EmulationModem Emulation AT Command Set Function Result ATHFunction Result CodeATP Mand state without disconnecting There is no Nvram support currently AT+MS Registers Function Range Units Saved Default AsciiRegister Function Range Units Saved Default Register Function Range Units Saved Default 17 11h =XON/XOFF &K4 Result Codes Short Long Form Special Features Modem Emulation Serial Power Feature Configuring RI PowerConfiguring DTR Power Serial Power Table OUT Configuring Industrial Automation with Modbus Special Features IA Industrial AutomationPage E c i a l F e a t u r e s S N M P About Snmp and the Device Server AgentConfiguration Procedure Web Interface MIBClick Backup/Restore Restore Copying the Configuration to and from a Remote HostUpgrading the Firmware Resetting Configuration to Defaults Interpreting the LEDs Color State IndicatesSafety Statements Device EIA 232/422/485 Switch Settings FunctionRack Mounting Installation PortServer TS 16 Rack and DC Rack Specifications External WiringMechanical PortServer TS PortServer TS 2/4 Mechanical Regulatory Notices Digi One TS, PortServer TS 2/4, PortServer TS 2/4 MEI Certifications Maximum Permissible Exposure Wireless only Digi Contact Information Digi Contacts