Digi 90000583_A manual Power Management

Page 27

Power Management

The Power Controller feature allows the administrators of the Digi CM to use console management to control power functions. Power control consists of three basic functions: on, off, and reboot (power cycle).There are two typical scenarios when using a power controller. The simplest scenario is a non-serial device connected to a power controller (for example, an environmental sensor controller or a tape backup device).

Note: Power controller settings can be automatically detected or configured manually.

Chapter 3 Configuration

27

Image 27
Contents Digi TS Family 90000583A Configuring the IP Address Chapter ConfigurationChapter Introduction Special Features Modem Emulation Setting Up RealPortSpecial Features Wireless Special Features Embedded ModemConfiguration Management Special Features Power Over the Serial PortsSpecial Features IA Industrial Automation Special Features SnmpDigi Contact Information Other Documents in the Library About This GuideSetup Overview Supported Devices About Configuration MethodsAccessing the Configuration from the Web Interface Feature Products Availability Configuration DetailsQuick Find Table DNS Introduction N f i g u r i n g t h e I P a d d r e s s Options for Configuring the IP Address and MaskConfiguring the IP Address Using ARP-Ping Configuring the IP Address with Digi Port Authority-RemoteAccessing the Digi Device Configuring an IP Address using Dhcp and RarpButton in the upper right corner is also available N f i g u r a t i o n Network SettingsProcedure for Using a Name Server Configuring the Serial Ports Service Base Socket Network PortConfiguration Port Profiles TCP Sockets Serial Bridging Printer Industrial Automation Modem Emulation Power Management Custom Feature Description User ConfigurationSnmp SSH Security ConfigurationSystem Configuration Click Outgoing Connections About Autoconnection Configuring a Port for AutoconnectionConfiguring a User for Autoconnection About RealPort T t i n g U p R e a l P o r tSetting Up RealPort Select Discover Digi Device from the CD Configuration ConsiderationsClick Network Wireless LAN Special Features Wireless Special Features Wireless Embedded Modem E c i a l F e a t u r e s E m b e d d e d M o d e mSpecial Features Embedded Modem Modem Emulation E c i a l F e a t u r e s M o d e m E m u l a t i o nSerial Device Digi Device Modem Emulation Cable SignalsScenarios for Modem Emulation Originating, Answering, and Disconnecting CallsATH Modem Emulation AT Command Set Function ResultCode Function ResultATP Mand state without disconnecting There is no Nvram support currently AT+MS Ascii Registers Function Range Units Saved DefaultRegister Function Range Units Saved Default Register Function Range Units Saved Default 17 11h =XON/XOFF &K4 Result Codes Short Long Form Special Features Modem Emulation Configuring RI Power Serial Power FeatureConfiguring DTR Power Serial Power Table OUT Special Features IA Industrial Automation Configuring Industrial Automation with ModbusPage About Snmp and the Device Server Agent E c i a l F e a t u r e s S N M PMIB Configuration Procedure Web InterfaceCopying the Configuration to and from a Remote Host Click Backup/Restore RestoreUpgrading the Firmware Resetting Configuration to Defaults Color State Indicates Interpreting the LEDsDevice EIA 232/422/485 Switch Settings Function Safety StatementsRack Mounting Installation PortServer TS 16 Rack and DC Rack External Wiring SpecificationsMechanical PortServer TS PortServer TS 2/4 Mechanical Regulatory Notices Digi One TS, PortServer TS 2/4, PortServer TS 2/4 MEI Certifications Maximum Permissible Exposure Wireless only Digi Contacts Digi Contact Information