Digi 90000583_A manual System Configuration

users.

Normal: all services are available.

Custom, which means you can select services to turn off. The default service level is Normal.

4.Click RADIUS and select Authenticate users via RADIUS server.

5.Enter the appropriate IP address and secret and click Apply. The secret is the password used for encryption of messages between the RADIUS server and the Digi device.

6.Click Reboot for changes to take effect.

System Configuration

System settings allow you to set the bandwidth (throughput or latency) the date and time, PPP connections, and SNMP traps.

1.Click System and enter the System Description (network name assigned to the Digi device), Contact (SNMP contact person -often the network administrator), Location (text description of the physical location of the Digi device), and Optimization (bandwidth used on the network) and click Apply

Note: Latency - Allows fast access to time-sensitive devices. Requires more network bandwidth.

Throughput - Allows better network performance at higher throughput.

2.Click Date/Time

3.Enter the date and time information and click Apply.

4.Click Reboot for changes to take effect.

PPP Settings

Under System Configuration, users can set the PPP (Point-to-Point Protocol) options to enable or disable the dynamic IP address pool. The dynamic IP address pool is a set of reserved IP addresses unique to the network that are assigned to the incoming connections. Users set the first IP address to use and the number of sequential addresses (plus one) to be reserved for assignment.

1.Click PPP.

2.If you are using PPP select Enable Dynamic IP Address Pool for Incoming Connections.

3.Enter the first reserved IP address of the incoming connections and the number of addresses to use and click Apply.

4.Click Incoming Connections > New Connection

Chapter 3 Configuration 31