NETGEAR UTM5-100NAS manual Managing the Configuration File, Snmp Settings, Trusted Snmp Hosts

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

2.Enter the settings as explained in Table 10-1.

Table 10-1. SNMP Settings

Setting	Description (or Subfield and Description)
Settings
Do You Want to	Select one of the following radio buttons:
Enable SNMP?	• Yes. Enable SNMP.
	• No. Disable SNMP. This is the default setting.
	Read Community	The community string to allow an SNMP manager access to
		the MIB objects of the UTM for the purpose of reading only.
		The default setting is public.
	Set Community	The community string to allow an SNMP manager access to
		the MIB objects of the UTM for the purpose of reading and
		writing. The default setting is private.
	Contact	The SNMP system contact information that is available to
		the SNMP manager. This setting is optional.
	Location	The physical location of the UTM. This setting is optional.

Trusted SNMP Hosts

Enter the IP addresses of the computers and devices to which you want to grant read-only (“GET”) or write (“SET”) privileges on the UTM. Separate IP addresses by a comma. To allow any trusted SNMP host access, leave the field blank, which is the default setting.

SNMP Traps

Enter the IP addresses of the SNMP management stations that are allowed to receive the UTM’s SNMP traps. Separate IP addresses by a comma. If you leave the field blank, which is the default setting, no SNMP management station can receive the UTM’s SNMP traps.

3.Click Apply to save your settings.

Managing the Configuration File

The configuration settings of the UTM are stored in a configuration file on the UTM. This file can be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory default settings.

Once the UTM is installed and works properly, make a back-up of the configuration file to a computer. If necessary, you can later restore the UTM settings from this file.

Network and System Management 10-15

v1.0, January 2010