NETGEAR UTM50-100NAS, UTM5-100NAS manual Rear Panel, Bottom Panel With Product Label, Receptacle

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Table 1-2.	LED Descriptions		(continued)
Object		Activity		Description
Active LED		Off		The WAN port is either not enabled or has no link to the Internet.
(dual-WAN
		On (Green)		The WAN port has a valid Internet connection.
port models
only)

Rear Panel

The rear panel of the UTM includes a cable lock receptacle, a console port, a reset button, and an AC power connection.

Security lock	Console port	Reset button	AC power
receptacle			receptacle
Figure 1-3

Viewed from left to right, the rear panel contains the following components:

1.Cable security lock receptacle.

2.Console port. Port for connecting to an optional console terminal. The ports has a DB9 male connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.

3.Factory default Reset button. Using a sharp object, press and hold this button for about eight seconds until the front panel Test light flashes to reset the UTM to factory default settings. All configuration settings are lost and the default password is restored.

4.AC power receptacle. Universal AC input (100-240 VAC, 50-60 Hz).

Bottom Panel With Product Label

The product label on the bottom of the UTM’s enclosure displays factory default, regulatory compliance, and other information (see Figure 1-4and Figure 1-5 on page 1-13and Figure 1-6 on page 1-14).

1-12 Introduction

v1.0, January 2010