NETGEAR UTM50-100NAS, UTM5-100NAS manual Setup Wizard WAN Settings, ISP Type

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Note: Click the Auto Detect action button at the bottom of the menu. The auto-detect process probes the WAN port for a range of connection methods and suggests one that your ISP is most likely to support.

Note: After you have completed the steps in the Setup Wizard, you can make changes to the WAN settings by selecting Network Config > WAN Settings. Then, for a dual-WAN port model, select WAN1 ISP Settings or WAN2 ISP Settings, and for

asingle-WAN port model, select WAN ISP Settings. For more information about these WAN settings, see “Configuring the Internet Connections” on page 3-2.

Table 2-2. Setup Wizard Step 2: WAN Settings

Setting	Description (or Subfield and Description)
ISP Login
Does your Internet	If you need to enter login information every time you connect to the Internet through
connection require a	your ISP, select the Yes radio button. Otherwise, select the No radio button, which
login?	is the default setting, and skip the ISP Type section below. If you select Yes, enter
	the following settings:
	Login	The login name that your ISP has assigned to you.
	Password	The password that your ISP has assigned to you.
ISP Type
What type of ISP	If your connection is PPPoE or PPTP, then you must log in. Select the Yes radio
connection do you	button. Based on the connection that you select, the text box fields that require
use?	data entry are highlighted. If your ISP has not assigned any login information, then
	select the No radio box and skip this section. If you select Yes, enter the following
	settings:
Austria (PPTP)	If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this
	radio button and enter the following settings:
	Account Name	The account name is also known as the host name or
		system name. Enter the valid account name for the PPTP
		connection (usually your email “ID” assigned by your ISP).
		Some ISPs require entering your full e-mail address here.
	Domain Name	Your domain name or workgroup name assigned by your
		ISP, or your ISP’s domain name. You may leave this field
		blank.

2-12 Using the Setup Wizard to Provision the UTM in Your Network

v1.0, January 2010