NETGEAR UTM50-100NAS Security Policy Editor Remote Party Settings, Only Connect Manually checkbox

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

3.Enter the settings as explained in Table 7-4.

Table 7-4. Security Policy Editor: Remote Party Settings

Setting	Description (or Subfield and Description)
Connection Security	Select the Secure radio button. If you want to connect manually only, select the
	Only Connect Manually checkbox.
ID Type	From the pull-down menu, select IP Subnet.
Subnet	Enter the LAN IP subnet address of the UTM that is displayed on the UTM’s
	VPN Policies screen (see Figure 7-10 on page 7-12). In this example, the
	subnet address is 192.168.1.0.
Mask	Enter the LAN IP subnet mask of the UTM that is displayed on the UTM’s VPN
	Policies screen (see Figure 7-10 on page 7-12). In this example, the subnet
	mask is 255.255.255.0.
Protocol	From the pull-down menu, select All.
Use	Select the Use checkbox. Then, from the pull-down menu, select Secure
	Gateway Tunnel.
	Left pull-down menu	From the left pull-down menu, select Domain Name.
		Then, below, enter the local FQDN that you entered on
		the UTM’s VPN Wizard screen (see Figure 7-9 on
		page 7-10). In this example, the domain name is
		utm_local.com.
	Right pull-down menu	From the right pull-down menu, select Gateway IP
ID Type		Address. Then, below, enter the IP address of the
		WAN interface that you selected on the UTM’s VPN
		Wizard screen (see Figure 7-9 on page 7-10). In this
		example, the WAN IP address is 192.168.50.61.
		Note: You can find the WAN IP address on the
		Connection Status screen for the selected WAN port.
		For more information, see “Viewing the WAN Ports
		Status” on page 11-27.

4.Click on the disk icon to save the configuration, or select File > Save from the Security Policy Editor menu.

7-14 Virtual Private Networking Using IPsec Connections

v1.0, January 2010