NETGEAR UTM5-100NAS Testing the Connections and Viewing Status Information, Detection checkbox

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

9.Enter the settings as explained in Table 7-6.

Table 7-6. Security Policy Editor: Security Policy Settings

Setting	Description (or Subfield and Description)
Select Phase 1 Negotiation	Select the Aggressive Mode radio button.
Mode
Enable Perfect Forward	Select the Enable Perfect Forward Secrecy (PFS) checkbox. From the
Secrecy (PFS)	pull-down menu below, select Diffie-Hellman Group 2.
Enable Replay Detection	Leave the default setting, which is selection of the Enable Replay
	Detection checkbox.

10.Click on the disk icon to save the configuration, or select File > Save from the Security Policy Editor menu

11.Close the VPN ProSafe VPN client.

Note: You do not need to open or change the settings on the Authentication (Phase 1) screen or its accompanying Proposal 1 and Proposal 2 screens, nor on the Key Exchange (Phase 2) screen or its accompanying Proposal 1 screen. Leave the default settings for these screens.

Testing the Connections and Viewing Status Information

Both the NETGEAR ProSafe VPN Client and the UTM provide VPN connection and status information. This information is useful for verifying the status of a connection and troubleshooting problems with a connection.

Testing the VPN Connection

To test a client connection and view the status and log information, follow these steps.

To test the client connection, from your PC, right-click on the VPN client icon in your Windows toolbar, and then select the VPN connection that you want to test. In the example that is shown in Figure 7-15 on page 7-18, select Connect... > My Connections\UTM_SJ.

Virtual Private Networking Using IPsec Connections 7-17

v1.0, January 2010