NETGEAR UTM5-100NAS manual Manually Adding or Editing a VPN Policy on, End Point Information a

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Table 7-2. (IPsec) VPN Wizard Settings for a Gateway-to-Gateway Tunnel (continued)

Setting	Description (or Subfield and Description)
This VPN tunnel will use	For the dual-WAN port models only, select one of the two radio buttons
following local WAN Interface	(WAN1 or WAN2) to specify which local WAN interface the VPN tunnel
(dual-WAN port models only)	uses as the local endpoint.
	Note: If a dual-WAN port model is configured to function in WAN auto-
	rollover mode, after completing the wizard, you must manually update
	the VPN policy to enable VPN rollover. For more information, see
	“Manually Adding or Editing a VPN Policy” on page 7-33.
End Point Informationa
What is the Remote WAN's IP	Enter the IP address or Internet name (FQDN) of the WAN interface on
Address or Internet Name?	the remote VPN tunnel endpoint.
What is the Local WAN's IP	When you select the Gateway radio button in the About VPN Wizard
Address or Internet Name?	section of the screen, the IP address of the UTM’s active WAN
	interface is automatically entered.
Secure Connection Remote Accessibility
What is the remote LAN IP	Enter the LAN IP address of the remote gateway.
Address?	Note: The remote LAN IP address must be in a different subnet than
	the local LAN IP address. For example, if the local subnet is
	192.168.1.x, then the remote subnet could be 192.168.10.x. but could
	not be 192.168.1.x. If this information is incorrect, the tunnel will fail to
	connect.
What is the remote LAN	Enter the LAN subnet mask of the remote gateway.
Subnet Mask?

a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and a FQDN is not supported.

.

Tip: To assure tunnels stay active, after completing the wizard, manually edit the VPN policy to enable keepalive which periodically sends ping packets to the host on the peer side of the network to keep the tunnel alive. For more information, see “The VPN Policies Screen” on page 7-31.

.

Tip: For DHCP WAN configurations, first set up the tunnel with IP addresses. After you have validated the connection, you can use the wizard to create new policies using the FQDN for the WAN addresses.

Virtual Private Networking Using IPsec Connections 7-7

v1.0, January 2010