NETGEAR UTM50-100NAS, UTM5-100NAS manual List of VPN Policies Information, Remote

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

2.Click the VPN Policies submenu tab. The VPN Policies screen displays. (Figure 7-22shows some examples.)

Figure 7-22

Each policy contains the data that are explained in Table 7-11. These fields are explained in more detail in Table 7-12 on page 7-35.

Table 7-11. List of VPN Policies Information

	Item	Description (or Subfield and Description)
	! (Status)	Indicates whether the policy is enabled (green circle) or disabled (grey circle). To
		enable or disable a policy, select the checkbox adjacent to the circle and click
		the Enable or Disable table button, as required.
	Name	The name that identifies the VPN policy. When you use the VPN Wizard to
		create a VPN policy, the name of the VPN policy (and of the automatically
		created accompanying IKE policy) is the Connection Name.
	Type	“Auto” or “Manual” as described previously (Auto is used during VPN Wizard
		configuration).
	Local	IP address (either a single address, range of address or subnet address) on your
		local LAN. Traffic must be from (or to) these addresses to be covered by this
		policy. (The subnet address is supplied as the default IP address when using the
		VPN Wizard).
	Remote	IP address or address range of the remote network. Traffic must be to (or from)
		these addresses to be covered by this policy. (The VPN Wizard default requires
		the remote LAN IP address and subnet mask).
	Auth	The authentication algorithm that is used for the VPN tunnel. This setting must
		match the setting on the remote endpoint.
	Encr	The encryption algorithm that is used for the VPN tunnel. This setting must
		match the setting on the remote endpoint.
7-32		Virtual Private Networking Using IPsec Connections

v1.0, January 2010