NETGEAR UTM5-100NAS LED Descriptions, Object Activity Description, LAN Ports, Dmz Led, WAN Ports

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Note: Figure 1-2shows a dual-WAN port model (the UTM25). Single-WAN port models contain the left WAN port that is shown in Figure 1-2but no right WAN port nor any Active WAN LEDs.

The function of each LED is described in Table 1-2.

Table 1-2. LED Descriptions

Object	Activity	Description
Power	On (Green)	Power is supplied to the UTM.
	Off	Power is not supplied to the UTM.
Test	On (Amber) during	Test mode: The UTM is initializing. After approximately 2 minutes,
	startup.	when the UTM has completed its initialization, the Test LED goes off.
	On (Amber) during	The initialization has failed or a hardware failure has occurred.
	any other time
	Blinking (Amber)	Writing to flash memory (during upgrading or resetting to defaults).
	Off	The system has booted successfully.
LAN Ports
Left LED	Off	The LAN port has no link.
	On (Green)	The LAN port has detected a link with a connected Ethernet device.
	Blink (Green)	Data is being transmitted or received by the LAN port.
Right LED	Off	The LAN port is operating at 10 Mbps.
	On (Amber)	The LAN port is operating at 100 Mbps.
	On (Green)	The LAN port is operating at 1000 Mbps.
DMZ LED	Off	Port 4 is operating as a normal LAN port.
	On (Green)	Port 4 is operating as a dedicated hardware DMZ port.
WAN Ports
Left LED	Off	The WAN port has no physical link, that is, no Ethernet cable is
		plugged into the UTM.
	On (Green)	The WAN port has a valid connection with a device that provides an
		Internet connection.
	Blink (Green)	Data is being transmitted or received by the WAN port.
Right LED	Off	The WAN port is operating at 10 Mbps.
	On (Amber)	The WAN port is operating at 100 Mbps.
	On (Green)	The WAN port is operating at 1000 Mbps.
Introduction		1-11

v1.0, January 2010