NETGEAR UTM5-100NAS manual Using Diagnostics Utilities, Email Reports Web Reports System Reports

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Table 11-17. Schedule Report Settings (continued)

Setting	Description (or Subfield and Description)
Reports	Select one or more checkboxes to specify the reports that are generated:
	•	Email Reports.
	•	Web Reports.
	•	System Reports.
	Note: You can select all three checkboxes, but you might generate a very large
	report.
Send Report by	Select this checkbox to enable the UTM to send the report to the recipients that
Email	you must specify below.
	Recipients		The e-mail addresses of the report recipients.
			Note: Use commas to separate email addresses.
Report List
Number of	Enter the number of reports that the UTM saves. The maximum number is 12.
Reports to Keep

4.Click Apply to save your settings.

Using Diagnostics Utilities

The UTM provides diagnostic tools that help you analyze traffic conditions and the status of the network. Two sets of tools are available:

•Network diagnostic tools. These tools include a ping utility, traceroute utility, and DNS lookup utility, and the option to display the routing table.

•Traffic diagnostic tools. These tools allow you to perform real-time, per-protocol traffic analysis between specific source and destination addresses and let you generate reports on network usage in your network.

Note: For normal operation, diagnostic tools are not required.

To display the Diagnostics screen, select Monitoring > Diagnostics from the menu. To facilitate the explanation of the tools, the Diagnostics screen is divided and presented in this manual in three figures (Figure 11-26 on page 11-44, Figure 11-27 on page 11-46, and Figure 11-28 on page 11-47).

Monitoring System Access and Performance 11-43

v1.0, January 2010