NETGEAR UTM50-100NAS, UTM5-100NAS manual DMZ Setup Settings

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Table 4-3. DMZ Setup Settings

Setting	Description (or Subfield and Description)
DMZ Port Setup
Do you want to	Select one of the following radio buttons:
enable DMZ Port?	• Yes. Enables you to configure the DMZ port settings. Enter the IP address
	and Subnet Mask fields (see below).
	• No. Allows to disable the DMZ port after you have configured it.
	IP Address	Enter the IP address of the DMZ port. Make sure that the
		DMZ port IP address and LAN port IP address are in
		different subnets (for example, an address outside the LAN
		address pool, such as 192.168.1.101).
	Subnet Mask	Enter the IP subnet mask of the DMZ port. The subnet mask
		specifies the network number portion of an IP address.
DHCP
Disable DHCP Server	If another device on your network is the DHCP server for the VLAN, or if you will
	manually configure the network settings of all of your computers, select the
	Disable DHCP Server radio button to disable the DHCP server. This is the
	default setting.
Enable DHCP Server	Select the Enable DHCP Server radio button to enable the UTM to function as
	a Dynamic Host Configuration Protocol (DHCP) server, providing TCP/IP
	configuration for all computers connected to the VLAN. Enter the following
	settings:
	Domain Name	This is optional. Enter the domain name of the UTM.
	Starting IP	Enter the starting IP address. This address specifies the first
	Address	of the contiguous addresses in the IP address pool. Any
		new DHCP client joining the LAN is assigned an IP address
		between this address and the Ending IP Address. The IP
		address 192.168.1.2 is the default start address.
	Ending IP	Enter the ending IP address. This address specifies the last
	Address	of the contiguous addresses in the IP address pool. Any
		new DHCP client joining the LAN is assigned an IP address
		between the Starting IP address and this IP address. The IP
		address 192.168.1.100 is the default ending address.
		Note: The starting and ending DHCP IP addresses should
		be in the same “network” as the LAN TCP/IP address of the
		UTM (the IP address in LAN TCP/IP section above).

4-20 LAN Configuration

v1.0, January 2010