NETGEAR UTM50-100NAS, UTM5-100NAS manual Destination

ProSecure Unified Threat Management (UTM) Appliance Reference Manual

Table 3-6. Protocol Binding Settings (Dual-WAN Port Models Only) (continued)

Setting	Description (or Subfield and Description)
Source Network	Group 1–Group 8	If this option is selected, the rule is applied to the devices
(continued)		that are assigned to the selected group.
		Note: You may also assign a customized name to a group
		(see “Changing Group Names in the Network Database” on
		page 4-16).
Destination	The destination network settings determine which Internet locations (based on
Network	their IP address) are covered by the rule. Select one of the following options
	from the pull-down menu:
	Any	All Internet IP address.
	Single address	In the Start Address field, enter the IP address that is
		covered by the rule.
	Address range	In the Start Address field and End Address field, enter the
		IP addresses for the range that is covered by the rule.

b.Click the Add table button in the rightmost column to add the protocol binding rule to the Protocol Binding table. The rule is automatically enabled, which is indicated by the “!” status icon that displays a green circle.

c.Repeat step a and step b for each protocol binding rule that you want to add to the Protocol Binding table.

d.If not all table entries are enabled, select the table entries that you want to enable, or click the Select All table button. Then, click the Enable table button.

e.Open the WAN2 Protocol Bindings screen and repeat step a through step d to set protocol bindings for the WAN2 port.

f.Return to the WAN Mode screen by selecting Network Config > WAN Settings from the menu and clicking the WAN Mode tab.

4.Click Apply to save your settings.

3-16 Manually Configuring Internet and WAN Settings

v1.0, January 2010