| select the channel of your preference (1 to 13). |
Associated Clients | Click “Show Active Clients” for the list of all |
| connected wireless clients. Click “Refresh” in the |
| new window to renew the list, and click “Close” to |
| close the window. |
| Note: If you have a pop‐up blocker installed, you |
| may have to disable it, or set it to allow the pop‐up |
| window to show up. |
Wireless Module | Select “Enable” to turn on the 2.4GHz wireless |
| signal and select “Disable” to turn it off. |
Click “Apply” to save the changes, or click “Cancel” to discard the changes. After you have clicked “Apply”, you will see the following message:
Click “Apply” to save the changes and restart the broadband router. It takes about 60 seconds for the broadband router to restart. Click “Continue” to configure other settings.
3‐4‐1‐2 Station‐Infrastructure
In “Station‐Infrastructure” mode, the router acts as both a wireless communication client and a wireless communication server. The following settings will appear in “Station‐Infrastructure” mode:
40