| close the window. |
| Note: If you have a pop‐up blocker installed, you |
| may have to disable it, or set it to allow the pop‐up |
| window to show up. |
MAC address 1 to 4 | Input the MAC addresses of the wireless access points |
| with which you wish to connect. |
Wireless Module | Select “Enable” to turn on the 2.4GHz wireless |
| signal and select “Disable” to turn it off. |
Click “Apply” to save the changes, or click “Cancel” to discard the changes. After you have clicked “Apply”, you will see the following message:
Click “Apply” to save the changes and restart the broadband router. It takes about 60 seconds for the broadband router to restart. Click “Continue” to configure other settings.
3‐4‐1‐6 Universal Repeater
In “Universal Repeater” mode, this broadband router acts as a wireless signal repeater to extend the wireless coverage of the specified wireless access point.
46