Edimax Technology AR-7286WNB user manual QoS, Choose the One-to-One , Many-to-One , Many-to-Many

The following table describes the parameters of this page:

Field	Description
	The Virtual server rule index for this VC. You can specify
Rule Index	10 rules in maximum. All the VCs with single IP will use
	the same Virtual Server rules.
Rule Type	Choose the One-to-One,Many-to-One,Many-to-Many
	Overload, Many-to-Many No Overload, or Server.
	Enter the local IP Address you plan to map to. Local Start
Local Start/End	IP is the starting local IP address and Local End IP is the
IP	ending local IP address. If the rule is for all local IPs, then
	the Start IP is 0.0.0.0 and the End IP is 255.255.255.255.
	Enter the public IP Address you want to use for NAT.
Public Start/End	Public Start IP is the starting public IP address and Public
IP	End IP is the ending public IP address. If you have a
	dynamic IP, enter 0.0.0.0 as the Public Start IP.

5.5.4.QoS

The QoS provides better service of selected network traffic over various technologies. This function can be set based on the physical LAN ports or wireless interfaces under IPv4 or IPv6 version respectively.

IP Version: IPv4

Choose Advanced Setup > QoS, the page shown in the following figure appears.

69