Edimax Technology AR-7286WNB user manual Filter, Support Web , FTP , Telnet , Snmp , Ping or AL L

Page 78

The following table describes the parameters and buttons of this page:

Field	Description
ACL Rule Index	You can establish sixteen ACL rules at most.
Active	Click to enable or disable the rule.
Secure IP	The rule is valid if the IP is in this range.
Address
Application	Support Web, FTP, Telnet, SNMP, Ping or ALL.
Interface	Support WAN, LAN or Both.
Access control	Only the devices whose MAC addresses are listed in the
Listing	Access Control Listing can access the router.

5.6.2.Filter

Choose Access Management > Filter, and the page shown in the following figure appears. Select IP/MAC Filter type. The user can set IP/MAC Filter, Application Filter and URL Filter.

5.6.2.1. IP/MAC Filter

Choose Access Management > Filter, select IP/MAC Filter from the drop- down list Filter Type Selection, and the page shown in the following figure appears. The user can set different IP filter rules of a given protocol (TCP, UDP or ICMP) and a specific direction (incoming, outgoing, or both) to filter the packets.

78

Image 78

Contents AR-7286WnA / AR-7286WnB Copyright Contents Trouble Shooting Package Contents Safety PrecautionsSystem Requirements LED Status & Button Definitions Front PanelWPS Rear Panel Features  DMZ QOS Connect the Adsl line Connect the router to your LAN networkConnect the power adapter to the router ConfigurationCheck the Adsl LED status Firewall settings PC LAN IP configurationPage Page Page Windows Windows 7, Windows Vista and Windows XPPage Page Windows Windows Vista Windows XP Page EZmax Setup Wizard Setup WizardPlease select your product Page Page Page Internet Connection Type PPPoE/PPPoA Bridge Mode Dynamic IP Address Static IP DescriptionPPoE/PPPoA VPIVCI Bridge Mode Dynamic IP Address Static IP Firmware Upgrade AdsltyperoutervcmuxPage Accessing the Router StatusDevice Info System Log Statistics Ethernet StatisticsAdsl Statistics Quick Start Wlan StatisticsPage Auto setup by ISP list Field Description ISPDynamic IP Address Bridge Mode Static IP AddressPPPoE/PPPoA Interface Setup InternetATM CBR, UBR, rtVBR, or nrtVBRMBS PCRSCR Select IPv4 , IPv4/IPv6 or IPv6IPv4 Address VC-Mux,1483 Routed IP LLCIPoA or 1483 Routed IP VC-MuxYou can choose Activated or Deactivated NATIPv6 Address Dual Stack LiteIPv4 Options You can select None , Both , in Only or OUT Only IPv6 OptionsSelect Activated or Deactivated Field Description Connection Setting Recommended Connect On-Demand or Connect ManuallyYou can select None, Both, in Only or OUT Only Field Description Dual Stack Lite You can choose 1483 Bridged IP LLC or 1483 BridgedLAN Dhcp Select Enable or Disable You may choose ManagedAddr or Other ConfigPage Wireless Field Description Access Point SettingsYou may choose Activated or Deactivated 802.11b+g, 802.11n, 802.11g+n or 802.11b+g+n 11n Settings Multiple SSIDs SettingsEven numbers only Select from Disabled , WEP-64Bits , WEP-128Bits Advanced SetupWPS Settings Wireless MAC Address FilterFirewall RoutingNAT Address Mapping for Multiple IP Service DMZ Field Description Overload , Many-to-Many No Overload , or Server QoSChoose the One-to-One , Many-to-One , Many-to-Many IP Version IPv4Field Description Quality of Service RuleMAC Dscp Select Low , Medium , High or HighestIP Version IPv6 IPv6 You may select Activated or Deactivated . Activated mustVlan Page Adsl Vlan IDAccess Management ACLChoose Annex a , Annex I , Annex A/L , Annex M or Filter Support Web , FTP , Telnet , Snmp , Ping or AL LSupport IP / MAC Filter, Application Filter and URL FilterChoose Both, Incoming or Outgoing Ymsg ICQMSN URL FilterSnmp URLUPnP Ddns CwmpURL for the CPE to connect to the ACS using the CPE WAN Maintenance AdministrationTime Zone Firmware Upgrade SysRestartDiagnostics Question Answer 255.255.255.0, respectivelyEU Declaration of Conformity Weee Directive & Product DisposalDeclaration of Conformity