Bay Technical Associates 400-ST1 manual Stack Up Configuration Example

Page 13

	t
	u
1	O	Unit 8
1		Unit 8
		Unit 7
		Unit 6
		Unit 5
		Unit 4
		Unit 3
		Unit 2
2		Unit 1
2

In

1 = Last unit

2 = Base unit34

3 = Cascade cable (PN 303978-A)

4 = Cascade max-return cable (PN 303979-A)

BS0033A

Figure 4. Stack Up Configuration Example

11

Image 13

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment Front Panel Components BayStack 400-ST1 Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Remaining stack units remain connected Redundant Cascade Stacking FeatureRedundant Cascade Stacking Feature Installation Removing the Filler Panel Installing the 400-ST1 Cascade ModuleInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Verifying the Installation Apply power to the AC power stripVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Accessing the Firmware Images Upgrading the BayStack 450 Switch FirmwareUpgrade Restrictions Accessing the Latest Documentation