5.Reconnect the cascade cable from unit 2 to the Cascade A In connector of (new) unit 5.
6.Connect a cascade cable from the Cascade A Out connector of unit 5 to the Cascade A In connector of unit 6.
7.Connect a cascade cable from the Cascade A Out connector of unit 6 to the Cascade A In connector of unit 3.
8.Renumber the order of the units for the new stack configuration (if desired).
You can renumber the unit numbers as described in “Setting Up the Stack Configuration” in the Using the BayStack 450 10/100/1000 Series Switch guide.
Adding Units to the End of a Stack
To add one or more units to the end of a stack, complete the following steps:
1.Determine the position of the new units in the existing stack (Figure 13).
For example, the shaded units (units 5 and 6) in Figure 13 show the two new units to be added to the stack. The new units are numbered as unit 5 and unit 6 because they are additions to the end of an existing 4 unit stack.
30