Bay Technical Associates 400-ST1 manual Accessing the Latest Documentation, Upgrade Restrictions

Page 39

3.After the BayStack 450 boot code image is downloaded, click on Version 1.1.0 at the BayStack 450 agent link.

Follow the prompts to download the BayStack 450 agent image. The agent image filename is b4501102.img

Be sure to download the BayStack 450 boot code image first, then download the BayStack 450 agent image.

Accessing the Latest Documentation

If you are upgrading your BayStack 450 switches, be sure to obtain the latest version of the Using the BayStack 450 10/100/1000 Series Switch guide. This guide provides instructions for setting up your stack configuration after you install the 400-ST1 Cascade Modules.

You can obtain the latest updates to your product documentation, including release notes, by visiting the Bay Networks Web site at the following location:

www.support.baynetworks.com/library/tpubs

Upgrade Restrictions

The following restrictions apply when upgrading the switch firmware:

•The firmware cannot be upgraded through a port that is configured for tagged traffic.

37

Image 39

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment Front Panel Components BayStack 400-ST1 Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Remaining stack units remain connected Redundant Cascade Stacking FeatureRedundant Cascade Stacking Feature Installation Removing the Filler Panel Installing the 400-ST1 Cascade ModuleInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Verifying the Installation Apply power to the AC power stripVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Accessing the Firmware Images Upgrading the BayStack 450 Switch FirmwareUpgrade Restrictions Accessing the Latest Documentation