Bay Technical Associates 400-ST1 manual Verifying the Installation

Page 27

Cas Pwr Up

Status Dwn

Cas Pwr Up

Status Dwn

RPSU Base		RPSU Base
1		2
11	12
	BayStack	450-24T Switch
23	24
	Cas

1 = Base unit only

2 = All other units in stack

BS0040A

Figure 11. Verifying the Installation

•The Base LED for the base unit only is on.

If one (or more) Base LEDs are blinking, no unit (or more than one unit) is configured as the base unit.

If the LEDs on any of the units in the stack are not as shown in Figure 11, cycle the power to the stack and verify the LEDs. Refer to Using the BayStack 450 10/100/1000 Series Switch guide to set up the stack and for detailed information about stacking, including troubleshooting.

25

Image 27

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment Front Panel Components BayStack 400-ST1 Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Remaining stack units remain connected Redundant Cascade Stacking FeatureRedundant Cascade Stacking Feature Installation Removing the Filler Panel Installing the 400-ST1 Cascade ModuleInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Verifying the Installation Apply power to the AC power stripVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Accessing the Firmware Images Upgrading the BayStack 450 Switch FirmwareUpgrade Restrictions Accessing the Latest Documentation