Bay Technical Associates 400-ST1 manual Cascade a Out Connector

Page 7

Cascade A Out Connector

Provides an attachment point for connecting this unit to another unit via the cascade cable. A return cable from another unit’s Cascade A Out connector to this unit’s Cascade A In connector completes the stack connection (see the example shown in Figure 3).

Note: For stacking three or more units (maximum 8 units per stack), order the optional

1meter (39.27 inch) cascade max-return cable (Bay Networks Order No. AL2018001).

Unit Select Switch

The Unit Select switch (up = Base) determines the base unit for the stack configuration (see “ Base Unit Description” on page 7). The Unit Select switch status is displayed on the BayStack 450 LED display panel (see the Using the BayStack 450 10/100/1000 Series Switch guide for details). When in the Base (up) position, all other Unit Select switches in the stack configuration must be set to Off (down).

5

Image 7

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment Front Panel Components BayStack 400-ST1 Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Remaining stack units remain connected Redundant Cascade Stacking FeatureRedundant Cascade Stacking Feature Installation Removing the Filler Panel Installing the 400-ST1 Cascade ModuleInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Verifying the Installation Apply power to the AC power stripVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Accessing the Firmware Images Upgrading the BayStack 450 Switch FirmwareUpgrade Restrictions Accessing the Latest Documentation