Bay Technical Associates 400-ST1 manual By Bay Networks, Inc

Page 2

© 1998 by Bay Networks, Inc.

All rights reserved.

Trademarks

Bay Networks is a registered trademark and BayStack is a trademark of Bay Networks, Inc. All other trademarks and registered trademarks are property of their respective owners.

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, Bay Networks, Inc. reserves the right to make changes to the products described in this document without notice.

Bay Networks, Inc. does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with the instruction manual, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures may be necessary to correct the interference at their own expense.

EN 55 022 Declaration of Conformance (UPDATE THIS FOR 400-ST1)

This is to certify that the Bay Networks BayStack 400-ST1 Cascade Module are shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class A (CISPR 22).

Warning: This device is a Class A product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take appropriate measures.

These products conform to the provisions of Council Directive 89/336/EEC and 72/23/EEC. The Declaration of Conformity is available on the Bay Networks World Wide Web site at www.baynetworks.com.

Image 2
Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment BayStack 400-ST1 Front Panel Components Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Redundant Cascade Stacking Feature Remaining stack units remain connectedRedundant Cascade Stacking Feature Installation Installing the 400-ST1 Cascade Module Removing the Filler PanelInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Apply power to the AC power strip Verifying the InstallationVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Upgrading the BayStack 450 Switch Firmware Accessing the Firmware ImagesAccessing the Latest Documentation Upgrade Restrictions