Bay Technical Associates 400-ST1 manual Proceed to Connecting Power on

Page 24

b.Connect the other end of the cascade cable to the cascade A In connector on the unit just below the base unit (unit 2), or just above the base unit if cascading up the stack.

c.Continue attaching the cascade cables until the last unit is configured.

A maximum of eight units can be configured per stack.

d.At the last unit in the stack, connect one end of a cascade max-return cable to the Cascade A Out connector. Connect the other end of the cascade max-return cable to the cascade A In connector on the base unit.

When stacking 3 or more units, the (optional) 1 meter (39.27 inch) cascade max-return cable is required (Bay Networks Part Number 303979-A).

8.Be sure all cable connections to the cascade connectors are secured firmly by the thumb screws on the cascade cable plugs.

9.Proceed to “ Connecting Power” on page 23.

22

Image 24

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment BayStack 400-ST1 Front Panel Components Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Redundant Cascade Stacking Feature Remaining stack units remain connectedRedundant Cascade Stacking Feature Installation Installing the 400-ST1 Cascade Module Removing the Filler PanelInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Apply power to the AC power strip Verifying the InstallationVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Upgrading the BayStack 450 Switch Firmware Accessing the Firmware ImagesAccessing the Latest Documentation Upgrade Restrictions