Bay Technical Associates manual BayStack 400-ST1 Front Panel Components

Page 6

If any items are missing or damaged, contact the sales agent or the customer service representative from whom you purchased the BayStack 400-ST1 cascade module. You will need a Phillips screwdriver for the installation.

Note: Unless otherwise specified, the terms “switch” and “unit” are used interchangeably in this guide.

BayStack 400-ST1 Front Panel Components

The front-panel components of the BayStack 400-ST1 Cascade Module are shown in Figure 2. Component descriptions follow the figure.

1

	Unit Select
Cascade A Out			Base	Cascade A In

4

23

1 = Blank connectors (unused)

2 = Cascade A Out connector

3 = Unit Select switch

4 = Cascade A In connector

BS0031A

Figure 2. Front Panel Components

4

Image 6

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment BayStack 400-ST1 Front Panel Components Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Redundant Cascade Stacking Feature Remaining stack units remain connectedRedundant Cascade Stacking Feature Installation Installing the 400-ST1 Cascade Module Removing the Filler PanelInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Apply power to the AC power strip Verifying the InstallationVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Upgrading the BayStack 450 Switch Firmware Accessing the Firmware ImagesAccessing the Latest Documentation Upgrade Restrictions