Bay Technical Associates manual Installing a 400-ST1 Cascade Module

Page 20

Caution: Be sure that the module slides in on the guides provided. Failure to align the guides could result in bent and broken pins

BS0037A

Figure 8. Installing a 400-ST1 Cascade Module

4.Press the module firmly into the chassis slot. Be sure that the module is fully seated into the mating connector.

5.Secure the module in the chassis by tightening the thumb screws on the module front panel.

6.Repeat Steps 1 to 5 for each switch that is to be configured with the 400-ST1 Cascade Module.

7.Proceed to the next section “ Installing and Connecting Multiple Switches” on page 19.

18

Image 20

Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment BayStack 400-ST1 Front Panel Components Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Redundant Cascade Stacking Feature Remaining stack units remain connectedRedundant Cascade Stacking Feature Installation Installing the 400-ST1 Cascade Module Removing the Filler PanelInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Apply power to the AC power strip Verifying the InstallationVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Upgrading the BayStack 450 Switch Firmware Accessing the Firmware ImagesAccessing the Latest Documentation Upgrade Restrictions