2.Remove the cascade cable from the Cascade A In connector at unit 5.
3.Remove the units (units 3 and 4) and install replacement units as required.
4.Renumber the order of the units for the new stack configuration (if desired).
You can renumber the unit numbers as described in “Setting Up the Stack Configuration” in the Using the BayStack 450 10/100/1000 Series Switch guide.
Removing/Replacing Nonadjacent Units
Note: Remove and replace the units individually to avoid segmenting the stack configuration.
To remove/replace nonadjacent units from an operating stack, complete the following steps (see Figure 15):
1.Remove the cascade cable from the Cascade A In connector at unit 3.
2.Remove the cascade cable from the Cascade A Out connector at unit 3.
3.Remove the unit (unit 3) and install the replacement unit as required.
4.Reconnect the cascade cables (removed in Steps 1 and 2) to unit 3.
34