Bay Technical Associates 400-ST1 manual Stack IP MAC address --- The stack IP MAC address is

Page 10

Note: You can renumber the units when you perform the initial setup of the stack as described in the Using the BayStack 450 10/100/1000 Series Switch guide.

Stack IP MAC address --- The stack IP MAC address is

automatically assigned during the stack initialization:

The base unit’s MAC address, with a software offset, is used for the stack IP MAC address.

For example, if the base unit’s MAC address is:

00-00-82-99-44-00

and the Stack software offset is: 1F

then the Stack IP MAC address becomes:

00-00-82-99-44-1F

If another unit in the stack is assigned as the base unit, the MAC address of the new base unit (with offset) now applies to the stack configuration. The original stack IP address still applies to the new base unit.

8

Image 10
Contents Installing BayStack 400-ST1 Cascade Module By Bay Networks, Inc Introduction For information about Go to Contents of Shipment BayStack 400-ST1 Front Panel Components Front Panel ComponentsCascade a Out Connector Connecting Cascade Cables Base Unit Description Stack IP MAC address --- The stack IP MAC address is Removing a unit from the stack--- if a unit is removed Stack Configurations Stack Up Configuration Example Stack Down Configuration Example Page Redundant Cascade Stacking Feature Remaining stack units remain connectedRedundant Cascade Stacking Feature Installation Installing the 400-ST1 Cascade Module Removing the Filler PanelInstalling a 400-ST1 Cascade Module Installing and Connecting Multiple Switches Only one unit in the stack can be the base unit Installing Cascade Cables Proceed to Connecting Power on Connecting Power Apply power to the AC power strip Verifying the InstallationVerifying the Installation Modifying an Existing Stack Configuration Assigning a New Base Unit to the Stack Adding Units to the Stack Add the new units to the desired location Adding Units to the End of a Stack Adding to End of Stack Removing/Replacing Units from the Stack Removing Adjacent Units Removing/Replacing Nonadjacent Units Repeat Steps 1 to 4 for unit Upgrading the BayStack 450 Switch Firmware Accessing the Firmware ImagesAccessing the Latest Documentation Upgrade Restrictions