Westell Technologies 2400 manual Router Connection via USB

User Guide 4-Port Router (Model 2400)

Congratulations! You have completed the USB hardware installation for your Router. You must now go to step 6 (INSTALL THE USB DRIVERS) to begin the USB drivers software installation.

Figure 3. Router Connection via USB

5.3Router Installation via 10/100Base-T Ethernet and USB (Simultaneous Hardware Installation)

The 4-Port Router supports simultaneous use of 10/100 Base-T Ethernet and USB ports. Refer to the instructions below for instructions on how to install your Router using both Ethernet and USB ports.

1.Connect the power supply cord to the power connector marked 12V on the rear panel of the Router. Plug the other end of the power supply cord into a surge-protected AC wall socket.

2.Connect the DSL phone cable from the DSL jackon the rear panel of the Router to the DSL-equipped telephone jack on the wall.

	WARNING: The connection to the Router’s DSL jack must come from a non-filtered connection to the
!	telephone jack on the wall. If you are using a microfilter, then be certain that the DSL phone cable is
	connected to the “DSL/HPN” non-filtered jack. You must use the phone cord that was provided with the
	Router kit.

3. Connect the USB cable from the USB connector		on the rear panel of the Router to the USB port on the
PC.
030-300331 Rev. A	10	October 2002