Westell Technologies 2400 manual Select the Ethernet Configuration

User Guide 4-Port Router (Model 2400)

Select the Ethernet Configuration

After clicking on OK in the previous step, the Network screen will be displayed. The Network screen shows the settings for the newly created location. From the Configure field in the Network screen, select Built-in Ethernet. Click Save.

NOTE: Default settings for the Built-in Ethernet configuration are sufficient to operate the Router.

Check the IP Connection

To verify that the computer is communicating with the Router, follow the instructions below.

1.Go to the “Apple” icon in the upper right corner of the screen and select System Preferences.

2.From the System Preferences screen, click on the Network icon. The Network screen will be displayed.

3.From the Configure field in the Network screen, select Built-in Ethernet.

4.View the IP address field. An IP address that begins with 192.168.1 should be displayed.

NOTE: The DHCP server provides this IP address. If this IP address is not displayed, check the Router’s wiring connection to the PC. If necessary, refer to section 5 for installation instructions.

030-300331 Rev. A 37 October 2002