Westell Technologies 2400 manual LAN Configuration, LAN Statistics

User Guide	4-Port Router (Model 2400)
	defined by the Router. A connection profile is information that the Router needs
	to establish a connection to your ISP. The “PPP Status” columns will show a
	status of “UP” if the Router is currently using that profile to communicate. The
	command button allows you to control the connection state.
Profile Editor	Selecting the “Profile Editor” link will allow you to define or change any of the
	connection profile settings.

L

LAN Configuration

This screen contains the setting that controls how the Router interacts with the local devices connected to the Router. Westell does not recommend that you change these settings. The following settings are displayed.

	LAN Configuration
Router IP Address	This controls the IP address that the Router uses for local communication.
Subnet Mask	This setting specifies the subnet mask to use to determine if an IP address
	belongs to your local network.
DHCP Start Address	This setting specifies the start of the IP address pool that the Router uses to
	assign IP addresses to local devices.
DHCP End Address	This setting specifies the end address of the IP address pool used for automatic
	configuration of local devices.
DNS Server Enable	DNS stands for Domain Name System. This is an Internet standard that
	facilitates communication among devices. This allows a name to be used when
	specifying a device instead of an IP address. Normally you want this enabled.
DHCP Server Enable	DHCP stands for Dynamic Host Configuration Protocol. This is an Internet
	standard that allows the Router to automatically assign IP addresses to devices
	connected on the LAN network. It is advised that this opt ion is set to Enabled.

LAN Statistics

This page contains information regarding the configuration and status of your Local LAN. The following settings are displayed.

	LAN Configuration
Device IP Address	This displays the IP address that the ADSL router uses for local communication.
DHCP NetMask	This displays the subnet address that the ADSL router’s DHCP server issues in
	DHCP responses.
DHCP Start Address	This setting specifies the start of the IP address pool that the modem uses to
	assign IP addresses to local devices.
DHCP End Address	This setting specifies the end address of the IP address pool used for automatic
	configuration of local devices.
DHCP Server Status	Displays the status, “ON” or “OFF” of the DHCP Server
DHCP Server	Displays which network “Public” or “Private” the DHCP server is serving IP
	addresses for.
Devices on LAN	This page displays the current devices the modem has found on your LAN. The
	name of the device, the Ethernet MAC address, and the status, “Active” or
	“Inactive” is displayed in the table.
030-300331 Rev. A	101	October 2002