STATUS/MENU DISPLAY
The upper level of the LCD displays status messages and menu items. Status messages are summarized in the table below.
Display | Description |
|
|
Powering Off | Displayed while ThurayaIP is powering down |
|
|
Fault {code} | A hardware fault exists, preventing operation (see |
| troubleshooting section for code explanations) |
Too Hot | A temporary thermal shutdown is about to occur |
Battery Hot | A temporary thermal shutdown is about to occur |
| due to battery heating |
|
|
No SIM | No SIM is detected in ThurayaIP |
Locked | A security code is needed (entered via wMMI) |
|
|
PIN | A SIM pin code is needed (entered via wMMI) |
Pointing | In pointing mode |
|
|
GPS old | GPS is older than the system time period allows |
Disconnected | The terminal has no IP connection to the network, |
| preventing data transfer |
Acquiring | The terminal is attempting to connect to the network |
|
|
Tx{rate}/Rx{rate} | Transmit and Receive streaming rates in kilobits per |
| second |
Standard | Best efforts quality of service in both directions |
NAVIGATION OF THE IMMI
You navigate among the options available in the iMMI by utilizing the Menu and Modify buttons. With the unit in its “normal” state displaying status indicators, you press the Menu button to view and modify Quality of Service (QoS) settings and LCD display parameters. Pressing the Modify button within a Menu option allows you to change the current setting.
The status display is the default display; after 30 seconds of inactivity, the display always reverts to the status display. Pressing the Menu button takes you through a circular list of menu items and then back to the status display. The two major menu options are the following:
Change Rate: Modify the QoS settings for Transmit and Receive.
LCD Contrast: Modify the contrast on your LCD.
ThurayaIP Satellite Modem User Guide | 9 |