Technics MT5634SMI-34, MT5634SMI-92 manual Register Name Register Description Host Access

Chapter 4 – SocketModem Parallel Interface – A Programmer’s Description

FIFO Operation

The 16-byte transmit and receive data FIFOs are enabled by the FIFO Control Register (FCR) bit-0. You can set the receive trigger level via FCR bits 6/7. The receiver FIFO section includes a time-out function to ensure data is delivered to the external host. An interrupt is generated whenever the Receive Holding Register (RHR) has not been read following the loading of a character or the receive trigger level has been reached.

Receive (RX) FIFO

The RX FIFO can be configured to be 16 words deep and 11 bits wide. Each word in the RX FIFO consists of 8 data bits and 3 error bits. The RX block of the MMM contains read and write pointers and status flag circuitry that need only to be presented with data (for input), reset, read/write control signals, and read/write clock signals. The RX block of the MMM internally manages the FIFO register file and pointers, and it provides simultaneous read/write capability (no contention problems).

The RX block of the MMM provides data (for output), FIFO full flag, FIFO empty flag, and an almost full flag which uses an associated predefined trigger level (obtained from the MMM FCR control register) to signal when the trigger level has been met. Four possible trigger levels may be selected by programming bits 6-7 of the FCR control register.

A typical (interrupt driven) write to the RX block is a two-step process. The MMM micro-controller must first write the 3 error bits to a shadow MMM LSR status register. Next, the micro-controller writes the data to the RX FIFO and during this write operation, the 3 error bits are directly loaded from the LSR shadow register into the bits 8- 10 of the selected (11 bit-wide) FIFO register. These error bits represent the parity error, framing error, and break interrupt signals associated with each data work transmission into the receive FIFO. When the receive FIFO is read, these error bits are loaded directly into bits 2-4 of the MMM LSR register.

A2	A1	A0	Register Name	Register Description	Host Access
0	0	0	RBR	Receive Buffer (RX FIFO)	DLAB = 0	R only
0	0	0	THR	Transmit Holding (TX	DLAB = 0	W only
0	0	1	IER	FIFO)	DLAB = 0	R/W
0	1	0	IIR	Interrupt Enable	DLAB = X	R only
0	1	0	FCR	Interrupt Identification	DLAB = X	W only
0	1	1	LCR	FIFO Control	DLAB = X	R/W
1	0	0	MCR	Line Control	DLAB = 0	R/W
1	0	1	LSR	Modem Control	DLAB = X	R only
1	1	0	MSR	Line Status	DLAB = X	R only
1	1	1	SCR	Modem Status	DLAB = 0	R/W
				Scratch pad
0	0	0	DLL	LSB of Divisor Latch	DLAB = 1	R/W
0	0	1	DLM	MSB of Divisor Latch	DLAB = 1	R/W
1	1	1	DLX	Divisor Latch	DLAB = 1	R/W
1	0	0	MCX	Status/Control	DLAB = 1	R/W

Note 1* The General Register set is accessible only when DS is a logic 0.

Note 2* The Baud Rate register set is accessible only when DS is a logic 0 and LCR bit-7 is a logic 1.

SocketModem Global MT5634SMI Developer’s Guide 17