Technics MT5634SMI-92, MT5634SMI-34 manual Modulation Handshake, Set Register Value

	Chapter 5 – AT Commands, S-Registers, and Result Codes
Nn	Modulation Handshake
On	Return Online to Data Mode
P	Pulse Dialing
Qn	Result Codes Enable/Disable
Sr=n	Set Register Value
Sr?	Read Register Value
T	Tone Dialing
Vn	Result Code Format
Wn	Result Code Options
Xn	Result Code Selection
Zn	Modem Reset
&Cn	Data Carrier Detect (DCD) Control
&Dn	Data Terminal Ready (DTR) Control
&En	XON/XOFF Pass-Through
&Fn	Load Factory Settings
&Gn	V.22bis Guard Tone Control
&Kn	Flow Control Selection
&Ln	Leased Line Operation
&Pn	Pulse Dial Make-to-Break Ratio Selection
&Qn	Asynchronous Communications Mode
&Sn	Data Set Ready (DSR) Control
&Tn	Loopback Test (V.54 Test) Commands
&V	Display Current Settings
&Wn	Store Current Configuration
&Zy=x	Store Dialing Command
\An	Select Maximum MNP Block Size
\Bn	Transmit Break
\Kn	Break Control
\Nn	Error Correction Mode Selection
\Qn	Flow Control Selection
\Tn	Inactivity Timer
\Vn	Protocol Result Code
-Cn	Data Calling Tone
%A	Adaptive Answer Result Code Enable
%B	View Numbers in Blacklist
%Cn	Data Compression Control
%DCn	AT Command Control
%En	Fallback and Fall Forward Control
%Hn	Direct Connect Enable
%Rn	Cisco Configuration
%Sn	Command Speed Response
$EBn	Asynchronous Word Length
$Dn	DTR Dialing
$MBn	Online BPS Speed
$SBn	Serial Port Baud Rate
#CBAn	Callback Attempts
#CBDn	Callback Delay
# CBF?	Callback Failed Attempts Display
# CBFR	Callback Failed Attempts Reset
# CBIn	Local Callback Inactivity Timer
# CBNy=n	Store Callback Password
# CBPn	Callback Parity
# CBRy	Callback Security Reset
# CBSn	Callback Enable/Disable
#Pn	Set 11-bit Parity
#Sx	Enter Setup Password
#S=x	Store Setup Password
+VDR=x, y	Distinctive Ring Report
+++AT<CR>	Escape Sequence
%%%AT<CR>	Remote Configuration Escape Sequence
V.92 Commands

SocketModem Global MT5634SMI Developer’s Guide 24