UTStarcom UT-300R2 manual Dhcp Server Settings for the LAN

Page 35

Chapter 4 Web-based Management 33

Figure 14 Configure DHCP server settings for the LAN

The three options for DHCP service are as follows:

1You may use the UT-300R2 as a DHCP server for your LAN.

2You can disable DHCP service and manually configure IP settings for all workstations.

You will use a DHCP service provided by your ISP, in which case DHCP should be disabled on the UT-300R2.

DHCP Server Settings for the LAN

The default setting of UT-300R2 's DHCP server is disabled. While you click to select the Enabled radio button under the DHCP Server option, the device will become the default gateway for DHCP clients that connected to it. When the UT- 300R2 is used for DHCP it becomes the default gateway for DHCP client connected to it. Keep in mind that if you change

Image 35

Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Device Introduction OverviewDevice Appearance FeaturesOverview Packing List Installation PlanningFront Panel Interfaces IntroductionRear Panel Connecting the Adsl LineCable Connections Connecting the UT-300R2 to the Ethernet LAN Computer to UT-300R2 Connection Hub or Switch to UT-300R2 ConnectionPower on Installation Planning Set up TCP/IP on Your PC Before Configuring UT-300R2Configure IP Settings on Your PC Set up Proxy ServiceFirst Time Log on Summary Web-based ManagementWeb-based Management Options of Web-based Configuring the WAN ConnectionWeb-based Management WAN Setting − Add menu Configuring a Bridged Connection for the WANDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN Disabling the Dhcp Server DNS Server SettingUse the UT-300R2 for Dhcp Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus NAT Virtual Server ConfigurationAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Firewall Configuration MenuAttacks Port Scans DMZ Ddns RIP Tools Administrator’s SettingsAdministrator Settings Menu Configure System TimeSave UT-300R2 Configuration Settings Save Configuration File to PC System Settings Load Saved Configuration FilesFirmware Update Restore Factory Default SettingsTools Log UT-300R2 Status InformationTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsAttachments Technical SpecificationsSafety and Environmental Tftp Glossary Attachments