UTStarcom UT-300R2 manual Set up Proxy Service, Configure IP Settings on Your PC

Page 17

14 Chapter 3 Before Configuring UT-300R2

Note: If Internet Protocol (TCP/IP) does not display as an installed component, you must install it.

Set up Proxy Service

In Windows Internet Explorer, you can check if a proxy server is enabled using the following procedure:

1Click on the START button, go to Settings and choose Control Panel.

2In the Control Panel window, double-click on the Internet Options icon

3Click the Connections tab and click on the LAN Settings button.

4Verify that the “Use proxy server” option is NOT checked. If it is checked, click in the checked box to deselect the option and click OK.

Configure IP Settings on Your PC

To use the web-based management software, launch your web browser software and use the LAN IP address of the UT-300R2 to access the management software. The default LAN IP address of the UT-300R2 is used in the Address bar of your web browser window. Type in http:// followed by the default IP address, 192.168.1.1 in the address bar of the browser. The URL in the address bar should read: http://192.168.1.1

Image 17
Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Device Introduction OverviewDevice Appearance FeaturesOverview Packing List Installation PlanningFront Panel Interfaces IntroductionRear Panel Connecting the Adsl LineCable Connections Connecting the UT-300R2 to the Ethernet LAN Computer to UT-300R2 Connection Hub or Switch to UT-300R2 ConnectionPower on Installation Planning Set up TCP/IP on Your PC Before Configuring UT-300R2Configure IP Settings on Your PC Set up Proxy ServiceFirst Time Log on Summary Web-based ManagementWeb-based Management Options of Web-based Configuring the WAN ConnectionWeb-based Management WAN Setting − Add menu Configuring a Bridged Connection for the WANDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN Disabling the Dhcp Server DNS Server SettingUse the UT-300R2 for Dhcp Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus NAT Virtual Server ConfigurationAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Firewall Configuration MenuAttacks Port Scans DMZ Ddns RIP Tools Administrator’s SettingsAdministrator Settings Menu Configure System TimeSave UT-300R2 Configuration Settings Save Configuration File to PC System Settings Load Saved Configuration FilesFirmware Update Restore Factory Default SettingsTools Log UT-300R2 Status InformationTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsAttachments Technical SpecificationsSafety and Environmental Tftp Glossary Attachments