UTStarcom UT-300R2 manual Directory Configuration and Read-only Menus

Page 48

46 Chapter 5 Advanced Configuration / Network Management

that application in the Special Applications List on your UT- 300R2 ADSL router.

Figure 20 Special Applications Menu

To configure a Special Applications List entry, define the following settings in the Virtual Server configuration menu located in the top half of the browser window.

Directory

Configuration and Read-only Menus

 

 

Status

This allows you to enable or disable any of the Special

Applications entered into the Special Applications List.

 

 

 

Name

You can assign a name to a Special Applications entry

for easier identification.

 

 

 

Image 48
Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Overview Device IntroductionFeatures Device AppearanceOverview Installation Planning Packing ListInterfaces Introduction Front PanelConnecting the Adsl Line Cable ConnectionsRear Panel Connecting the UT-300R2 to the Ethernet LAN Hub or Switch to UT-300R2 Connection Computer to UT-300R2 ConnectionPower on Installation Planning Before Configuring UT-300R2 Set up TCP/IP on Your PCSet up Proxy Service Configure IP Settings on Your PCFirst Time Log on Web-based Management SummaryWeb-based Management Configuring the WAN Connection Options of Web-basedWeb-based Management Configuring a Bridged Connection for the WAN WAN Setting − Add menuDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN DNS Server Setting Use the UT-300R2 for DhcpDisabling the Dhcp Server Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus Virtual Server Configuration NATAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Configuration Menu FirewallAttacks Port Scans DMZ Ddns RIP Administrator’s Settings ToolsConfigure System Time Administrator Settings MenuSave UT-300R2 Configuration Settings Save Configuration File to PC Load Saved Configuration Files System SettingsRestore Factory Default Settings Firmware UpdateTools UT-300R2 Status Information LogTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsTechnical Specifications AttachmentsSafety and Environmental Tftp Glossary Attachments