UTStarcom UT-300R2 manual Tools, Administrator’s Settings

Page 69

6 Tools

Click the Tools tab to reveal the menu buttons for various functions located in this directory. These menus are used to change the system password used to access the web manager, to save or load UT-300R2 configuration settings, upgrade the device firmware, save current configuration settings, restore default settings, and to perform miscellaneous actions such performing Ping tests. These menus are described below.

Administrator’s Settings

Click the Administrator of Tools to set the administrator’s setting. Administrator has read/write ability on the web page and can make some changes. You can change the Admin account password here for personal security. To change the password used to access the UT-300R2’s web manager, Type the a new password and confirm the password to be certain you have typed it correctly. Click the Apply button to activate the new password.

Image 69

Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Device Introduction OverviewDevice Appearance FeaturesOverview Packing List Installation PlanningFront Panel Interfaces IntroductionConnecting the Adsl Line Cable ConnectionsRear Panel Connecting the UT-300R2 to the Ethernet LAN Computer to UT-300R2 Connection Hub or Switch to UT-300R2 ConnectionPower on Installation Planning Set up TCP/IP on Your PC Before Configuring UT-300R2Configure IP Settings on Your PC Set up Proxy ServiceFirst Time Log on Summary Web-based ManagementWeb-based Management Options of Web-based Configuring the WAN ConnectionWeb-based Management WAN Setting − Add menu Configuring a Bridged Connection for the WANDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN DNS Server Setting Use the UT-300R2 for DhcpDisabling the Dhcp Server Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus NAT Virtual Server ConfigurationAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Firewall Configuration MenuAttacks Port Scans DMZ Ddns RIP Tools Administrator’s SettingsAdministrator Settings Menu Configure System TimeSave UT-300R2 Configuration Settings Save Configuration File to PC System Settings Load Saved Configuration FilesFirmware Update Restore Factory Default SettingsTools Log UT-300R2 Status InformationTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsAttachments Technical SpecificationsSafety and Environmental Tftp Glossary Attachments