UTStarcom UT-300R2 manual Installation Planning, Packing List

Page 9

2

Installation Planning

Before installing the UT-300R2, you should gather information and equipment needed to install the device, then Install the hardware as instructed, connect the cables to the device and power on the UT-300R2. Prior to accessing the web-based software built into the UT-300R2, you should check the IP settings on your computer and change them if necessary.

Packing List

Please check the package contents by comparing them with the following list:

One UT-300R2

One telephone line

One straight-through Ethernet Cable

One Power Adapter

One User CD-ROM

One Splitter

Image 9
Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Device Introduction OverviewDevice Appearance FeaturesOverview Packing List Installation PlanningFront Panel Interfaces IntroductionConnecting the Adsl Line Cable ConnectionsRear Panel Connecting the UT-300R2 to the Ethernet LAN Computer to UT-300R2 Connection Hub or Switch to UT-300R2 ConnectionPower on Installation Planning Set up TCP/IP on Your PC Before Configuring UT-300R2Configure IP Settings on Your PC Set up Proxy ServiceFirst Time Log on Summary Web-based ManagementWeb-based Management Options of Web-based Configuring the WAN ConnectionWeb-based Management WAN Setting − Add menu Configuring a Bridged Connection for the WANDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN DNS Server Setting Use the UT-300R2 for DhcpDisabling the Dhcp Server Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus NAT Virtual Server ConfigurationAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Firewall Configuration MenuAttacks Port Scans DMZ Ddns RIP Tools Administrator’s SettingsAdministrator Settings Menu Configure System TimeSave UT-300R2 Configuration Settings Save Configuration File to PC System Settings Load Saved Configuration FilesFirmware Update Restore Factory Default SettingsTools Log UT-300R2 Status InformationTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsAttachments Technical SpecificationsSafety and Environmental Tftp Glossary Attachments