UTStarcom UT-300R2 manual Restore Factory Default Settings, Firmware Update

Page 74

72 Chapter 6 Tools

Restore Factory Default Settings

To reset the UT-300R2 to its factory default settings, click the Restore button. You will be prompted to confirm your decision to reset the UT-300R2. The UT-300R2 will reboot with the factory default settings including IP settings.

Firmware Update

Note: Performing a Firmware Upgrade can sometimes change the configuration settings. Be sure to back-up the UT-300R2’s configuration settings before upgrading the firmware.

Use the Firmware Upgrade menu to load the latest firmware for the device. Note that the device configuration settings may return to the factory default settings, so make sure you save the configuration settings with the System Settings menu described above.

Use the Firmware Upgrade menu to load the latest firmware for the device. Note that the device configuration settings may return to the factory default settings, so make sure you save the configuration settings with the System Settings menu described above.

Image 74

Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Overview Device IntroductionFeatures Device AppearanceOverview Installation Planning Packing ListInterfaces Introduction Front PanelRear Panel Connecting the Adsl LineCable Connections Connecting the UT-300R2 to the Ethernet LAN Hub or Switch to UT-300R2 Connection Computer to UT-300R2 ConnectionPower on Installation Planning Before Configuring UT-300R2 Set up TCP/IP on Your PCSet up Proxy Service Configure IP Settings on Your PCFirst Time Log on Web-based Management SummaryWeb-based Management Configuring the WAN Connection Options of Web-basedWeb-based Management Configuring a Bridged Connection for the WAN WAN Setting − Add menuDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN Disabling the Dhcp Server DNS Server SettingUse the UT-300R2 for Dhcp Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus Virtual Server Configuration NATAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Configuration Menu FirewallAttacks Port Scans DMZ Ddns RIP Administrator’s Settings ToolsConfigure System Time Administrator Settings MenuSave UT-300R2 Configuration Settings Save Configuration File to PC Load Saved Configuration Files System SettingsRestore Factory Default Settings Firmware UpdateTools UT-300R2 Status Information LogTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsTechnical Specifications AttachmentsSafety and Environmental Tftp Glossary Attachments