UTStarcom UT-300R2 manual Rip

Page 68

66 Chapter 5 Advanced Configuration / Network Management

RIP

Figure 28 RIP menu

RIP can be enabled on any existing WAN or LAN interfaces. It may be specified to receive RIP requests and reply to them, it can be specified to send RIP queries, or to both receive and send RIP packets. Furthermore, the RIP version can be specified. The table below lists the parameters that can be specified for the pull-down RIP menus. Click the Apply button to setup RIP as specified.

Current RIP configurations cannot be edited. To remove a RIP configuration, click on the trashcan icon for the set. Remember to save the configuration changes.

Image 68

Contents UT-300R2 ADSL2/2+Modem United States Government Legends Contents UT-300R2 Status Information Attachments Overview Device IntroductionFeatures Device AppearanceOverview Installation Planning Packing ListInterfaces Introduction Front PanelRear Panel Connecting the Adsl LineCable Connections Connecting the UT-300R2 to the Ethernet LAN Hub or Switch to UT-300R2 Connection Computer to UT-300R2 ConnectionPower on Installation Planning Before Configuring UT-300R2 Set up TCP/IP on Your PCSet up Proxy Service Configure IP Settings on Your PCFirst Time Log on Web-based Management SummaryWeb-based Management Configuring the WAN Connection Options of Web-basedWeb-based Management Configuring a Bridged Connection for the WAN WAN Setting − Add menuDepending on which WAN Type and Connection Type you select Web-based Management Configuring a Routed/Bridged Connection for the WAN WAN Settings Menu Routed/Bridged Mode Configuring a PPP Connection for the WAN Web-based Management Dynamic IP Address for the WAN Connection Web-based Management Static IP Address for WAN Web-based Management Dhcp Configuration Dhcp Server Settings for the LAN Disabling the Dhcp Server DNS Server SettingUse the UT-300R2 for Dhcp Configuring the LAN Connection Web-based Management Save New Settings Web-based Management Advanced Configuration / Network Management Advanced configuration menus Virtual Server Configuration NATAdvanced Configuration / Network Management Advanced Configuration / Network Management Directory Configuration and Read-only Menus Special Application Configuration Directory Configuration and Read-only Menus This is the TCP or UDP port number that will be used Configure a Filter Rule-IP Filters Advanced Configuration / Network Management Advanced Configuration / Network Management MAC Select Allow to permit packets to pass through Configuring a Filter Rule- MAC Filters Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-URL Blocking Advanced Configuration / Network Management Directory Configuration and Read-only Menus Configuring a Filter Rule-Domain Blocking Advanced Configuration / Network Management This radio button selects the URL filter rule Firewall Configuration Menu FirewallAttacks Port Scans DMZ Ddns RIP Administrator’s Settings ToolsConfigure System Time Administrator Settings MenuSave UT-300R2 Configuration Settings Save Configuration File to PC Load Saved Configuration Files System SettingsRestore Factory Default Settings Firmware UpdateTools UT-300R2 Status Information LogTraffic Statistics Traffic StatisticsDiagnostics DiagnosticsTechnical Specifications AttachmentsSafety and Environmental Tftp Glossary Attachments