RAD Data comm IPmux-16 Installation and Setup, Setting Jumpers, Connecting Interfaces and Cables

Chapter 2 Installation IPmux-16Installation and Operation Manual

2.5 Installation and Setup

Setting Jumpers

IPmux-16 internal jumpers and switches do not need to be configured by the user and therefore removing the product cover is not required.

Connecting Interfaces and Cables

Figure 2-2and Figure 2-3illustrate the rear and front panel options available for IPmux-16.

Figure 2-2. IPmux-16 Front Panel

PS1 POWER POWER

I	I
O	O

~100-240VAC 3A T 125V ~100-240VAC 3A T 125V

EXT. CLK ALARMS

PS2

Figure 2-3. IPmux-16 Rear Panel

Grounding

Interrupting the protective grounding conductor (inside or outside the instrument) or disconnecting the protective earth terminal can make this instrument dangerous. Intentional interruption is prohibited.

Before switching ON this instrument and before connecting any other cable, the protective earth terminals of this instrument must be connected to the protective ground conductor of the power cord.

Warning

Fuses

Make sure that only fuses with the required rated current and specified type,

2 A T 250V as marked on the IPmux-16 rear panel, are used for replacement.

Whenever it is likely that the protection offered by fuses has been impaired, the instrument must be made inoperative and be secured to prevent any operation.

2-4 Installation and Setup